UVDTF INSTRUCTION

IMPORTANT - DO NOT USE ALCOHOL OR ANY CLEANING SOLUTIONS BEFORE APPLYING YOUR UVDTF.

 

STEP 1:

Measure your transfer against the product you are applying to, to ensure it fits. Make sure you cut any excess, being careful to avoid your design.

 

STEP 2:

Your transfer needs to be warmed up! This will help when removing the laminated cover. You can warm up by gently rubbing the design in your hands.

 

STEP 3:

Grab yourself a thick card / bank card and gently rub over your design before peeling from the carrier sheet.

 

If you have any difficulty removing your design, please make sure you repeat this step.

 

STEP 4:

Place your transfer against the product of choice - remember as soon as it’s stuck in place, you cannot move it. Be gentle and cautious of your positioning.

 

STEP 5:

Begin to press your transfer down, working your way from the centre outwards. Make sure you push out any air bubbles you can see. You may be able to pop any remaining bubbles once finished by using a fine pin needle.

 

STEP 6:

Now the fun really begins! It’s time to slowly remove the carrier sheet - aka the clear film. Start off slowly and make sure you don’t remove any of your design.

 

We recommend leaving the final product a minimum of 24-48 hours before getting wet.

 

Once finished you may notice a small amount of adhesive left over, don't panic - this is normal.

 

This can be removed after your 24-48 hour wait period with a gentle hand and some warm water.

 

Make sure not to rub the design too hard, we wouldn’t want it to begin to lift.